If you ordered a hazmat item. A hazard fee by our shipping company will be added to shipping total. this only applys to items that says in the description that the item that you are ordering has a hazmat fee.
FOR: PISTONS COMBUSTION CHAMBERS VALVES *********************** APPLICATION:
*All parts mnust be clean of all oils, dirt or other debris. *Blast lightly with
120 grit al oxide or similar hard sharp material at low pressure *Degrease with
a non petroleum based solvent. Allow to full evaporate *After STIRRING and
shaking apply coating. Spray at an air pressure of about 60 psi through a fine
nozzle. *The coating has nearly the same appearance as the blasted part, so
apply only enough to give a thin "wet" look to the part. *Allow to dry to a
"matte" finish. If humid use a fan or other tool to move air over the part to
aid in drying. *Bake at a minimum of 300f for 1 hour. *Inspect part after cure
for blisters, cracking or flaking. The coating should have a slight gold tint.
*DO NOT ASSEMBLE IF DAMAGE VISIBLE
