If you ordered a hazmat item. A hazard fee by our shipping company will be added to shipping total. this only applys to items that says in the description that the item that you are ordering has a hazmat fee.
•
The parts to be coated must be clean and free of all oils,
grease, moisture, dust, scale or corrosion. Sand blast with 120 grit aluminum
oxide or similar.
•
Use an airbrush or detail touch-up spray gun with a 1 mm or
smaller tip, to apply the coating. Continuously agitate the coating while in the
spray gun.
•
This coating should be applied at temperatures above 75° F.
at about 20 to 30 psi. for best results.
•
Spray the coating in all hard to reach areas first. Spray a
light tack coat first then a thin wet coat can then be applied. Your finished
cured coating thickness should be about .001”.
•
Inspect part for complete coverage. Part should be glossy wet
without runs or sags.
•
Allow coating to dry to the touch, normally the part may be
put in service after 8 to 12 hours. Full cure time depends on temperature and
humidity, from 1 to 4 days.
