If you ordered a hazmat item. A hazard fee by our shipping company will be added to shipping total. this only applys to items that says in the description that the item that you are ordering has a hazmat fee.
APPLICATION:
Sandblast all parts with 120 grit aluminum oxide.
DO NOT USE GLASSBEAD. Clean metal using conventional
cleaning methods, with acetone, lacquer thinner or
other similar non-petroleum based solvent.When the
surface is clean and dry, apply a thin even layer of
coating using an airbrush, detail touch-up gun
or other spray equipment that allows for application of
a thin film of approximately .001" to .0015". Avoid
excessive build-up of material as this can lead to loss
of adhesion. DO NOT APPLY A SECOND COAT AFTER
THE COATING DRIES. The coating will air dry
to the touch in a few minutes. Install on vehicle, as the coating will cure with exaust heat.
CAUTION: Excessive exhaust heat due to a poorly tuned engine can damage the coating during the cure period. Do not install on a new engine untill all adjustments have been made to the valves, timing and jetting. Allow the engine to idle, or drive gently for approximately 30 minutes or until no vapor/smoke is given off by the coating. MAINTAIN adequate ventilation during this process.
